QuickStream DV - Portable FireWire Hard Disk DV Recorder - 6
1. AC Adapter Port – The AC Adapter port of the QuickStream DV can
accept any voltage between 6 to 18V to power and charge the device. It
is a reverse polarity plug so when using it with a power supply other than
the included AC Adapter please check the polarity of your power supply.
2. Power Button – This button is labeled POWER and is the left-most button
on the control panel. This button turns the QuickStream DV on or off
provided that the Master Power Switch (described below) is in the left, or
‘on’, position. This button glows green when activated.
3. Review Button – This button is labeled REVIEW and is located in between
the POWER and RECORD buttons. When connected to a DV camcorder
and the DV camcorder is in VTR/VCR mode, pressing this button plays
back the last recorded clip over FireWire via the DV camcorder’s own LCD
screen.
4. Record Button – This button is labeled RECORD and is located directly in
the middle of the control panel. This button glows red when activated.
5. FireWire port – six-pin FireWire port into which the FireWire cable from a
DV camera or computer is plugged.
6. Master Power Switch – This switch, labeled MASTER, is located between
the FireWire port and the Record button. It must be in the left-most,
labeled “ON”, position during normal use of the QuickStream DV. If the
QuickStream DV is to be stored for any length of time or any time it is
transported, then this switched should be moved to the right-most position.
This will preserve battery power during transportation and long periods of
non-use.
7. Quick-Erase Button - To the far right of the end panel (immediate right of
the FireWire port) is a recessed push-button. This is the Quick-Erase
button and serves to erase all DV clips the QuickStream DV has recorded.
8. Charge-Indicator LED – In between the RECORD button and the FireWire
port is a blue LED which glows brightly when the QuickStream DV has
enough current from either a powered FireWire bus or from an AC adapter
to charge its internal Lithium-Ion polymer battery.
Connect the QuickStream DV to your DV Camcorder
Mounting the QuickStream DV to your DV Camcorder’s Accessory Shoe
The MCE QuickStream DV’s industial designed enclosure incorporates a 1/4-20
screw socket (see Fig. 1)... The very same screw socket that is found on the
bottom of virtually every still and video camera ever made. And included with the
QuickStream DV is an accessory/hot shoe adapter (see Fig. 2) for mounting it
directly to your DV camcorder's accessory/hot shoe.
(14 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales